ASHLY
ne8250.70c
Network 8-Chan Power Amp with CobraNet
Connecting and controlling an amplifier for networked systems has now been simplified with Ashly’s NE Series amplifiers. Network Enabled (NE) amplifiers offer ease of use, setup and control using standard 10/100 Ethernet protocol and Protea NE Software. No special outboard control units are needed.
Eight, eight-channel models with output power at 250W are available to fill a wide variety of low impedance, 25V, 70V and 100V performance installation or constant voltage applications. NE Series amplifiers are offered two ways; standard input with euroblock connectors and "pe" (Protea Enabled) with euroblock input connectors and world renowned Protea DSP signal processing.
The DSP signal processing library is extensive and utilizes two SHARC 32-bit / 96kHz processors. Processing blocks include Graphic, Parametric, Notch and Shelving Equalization, High-, Low- and All-Pass Filters (HPF/LPF/APF) with up to 48dB/Octave slopes, Delay, Compressor/Limiter, Gate, Ducking, Auto-leveler, Gain and Signal Generators (sinewave, white and pink noise). A full Matrix Mixer with assignable routing allows any input to drive any or all amplifier outputs. Presets can be used to store and retrieve global parameters of an entire
amplifier’s control surface and DSP section.
Additionally, each amplifier also provides DC voltage control of the attenuators which makes it a snap to control volume from remote locations, preset recall, Remote Power Standby and data in and out ports for connecting accessories like the WR-5 to control user selected parameters. There are LED indicators for power, standby, protect, network communications and each channel has a four-step signal meter, bridge mono, temperature and current indicators.
Four-channel Mic-pre, AES/EBU, EtherSound, and Cobranet modules will be available as options. Four-channel NE series amplifiers are also available
Features
• Eight Channel Amplifier
• Ethernet control Is standard
• Low-Z, 25V, 70V and 100V Models
• Extensive DSP Available
• Easy and intuitive user interface
• Extensive protection circuitry
• Safety/Compliance: CE, FCC, RoHS
• Optional CobraNet, EtherSound, AES/EBU, Mic Preamps
Front panel:
• Level attenuators for each channel
• Power switch can be disabled by software
• 4-Step Signal Level and Clip LEDs
Rear panel:
• 10/100 Ethernet port
• Euroblock inputs
• Euroblock outputs
• Remote level control
• Preset recall
• Remote power standby
• Data in and out ports
Watts per channel
Model 8 ohms 4 ohms 25V/70V/100V
ne8250 150 250 NR
ne8250.25 NR NR 250
ne8250.75 NR NR 250
ne8250.10 NR NR 250
Input Options
Four-Channel Mic Pre
AES/EBU
CobraNet
EtherSound
Accessories
WR-1 2-ch Level Control
WR-2 Four Position Switch
WR-5 Programmable Selector
neWR-5 Programmable Network Remote
neRD-8/16 Network Fader Remotes
